Kenwood 107VR Instruction Manual page 12

2
Turn the power ON.
;
ON/STANDBY
EA} select the SPEAKERS key setting.
A- SPEAKERS -8
SRS 3D SPEAKERS
' ;
| stanogy O OE 9
"c nas
Light up tne ina-cator of the desred speakers
3 | Select the input source.
JO7VR [En]
Keys or controls to be used In this operation
8 can be switched by operating the SPEAKERS A and
B keys as described below. -
For the speaker connection method: ~ 8.
eS The sound output from SPEAKERS A and SPEAKERS
Note)
A,B OFF : The speakers do not output sound. Use this position when
listening sound through headphones, etc
AON The speakers connected to the SPEAKERS A terminals on
the rear panel output sound
A OFF The speakers connected to SPEAKERS A, center speaker
and sub-woofer do not output sound
BON The speakers connected to the SPEAKERS B terminals on
the rear panel output sound
A,BON - The speakers connected to the SPEAKERS A and B term:
nals on the rear panel output sound simultaneously
When the surround mode is entered while both SPEAKERS A and B are
ON, SPEAKERS B are turned OFF automatically
Ifthe SPEAKERS B key 1s pressed at this time, SPEAKERS B are turned
ON, and the surround mode is canceled
e@When the surround mode is entered while SPEAKERS 8 are ON,
SPEAKERS B are turned OFF automatically, SPEAKERS A are turned
ON and surround play starts
INPUT SELECTOR
iC)
Play the selected source.
5 | Adjust the volume.
The input sources are switched in the following order
r 1 TUNER (frequency display)
The selected source 1s
2 PHONO displayed
3 VIDEQ1 (TAPE 1 or MD)*! | -
4cD
md
5 VIDEO2 oT
le 6 AV AUX
ties
*': Switching the VIDEO1 display to TAPE? or MD display
When a KENWOOD cassette deck or MD recorder is connected in the
ISL16] system control mode, the VIDEO 1 input should be switched to
the TAPE1 or MD input with the following operation
@QSelect VIDEO1 with the INPUT SELECTOR.
@Press and hold the AUTO key for more than 2 Note
seconds to select TAPE1 or MO.
{ ]
1 VIDEO1 ~— 2 TAPE1 - 3 MD
VOLUME CONTROL
(CY)
To decrease To increase
vclume DOWN! ue volume
Volume level is displayed
{
tert) 2 fp co la a i
Yok Oo co
eThe time taken till the volume level is displayed is variable depending
on the current operating condition
@Rotating the VOLUME CONTROL at a higher speed increases the
amount of volume change {Al VOLUME function)
@The sound of input source cannot be listened to while TAPE 2
MONITOR is ON