Philips 29PT9416/58R Instruction Manual page 27

2030.3 gb 22-05-2001 10:29 Pagina 27
Connect Extra loudspeakers / Amplifier
Stereo amplifier and two extra FRONT speakers
To enhance the sound reproduction of your TV you can connect two extra
speakers via an external amplifier.
Connect the audio cables to the audio input of your amplifier and to
AUDIO L
The output level is controlled by the volume control of your TV.
AUDIO
Note: Switch off the TV and your audio amplifier before connecting them.
Set the audio amplifier's volume to minimum.
Select
See Surround settings, p. 13 for the available Surround modes.
Adjust the volume of the audio amplifier.
You may make use of the Test tone function in the Surround Settings menu,
see p. 13, to have a reference of the loudness of the separate loudspeakers.
Note: Once you have adjusted the volume of the amplifier, do not change it while
watching TV as the whole configuration operates with the volume
adjustment of your TV.
REAR multimedia loudspeakers
You can enjoy Dolby Pro Logic Surround sound by connecting two rear
loudspeakers with built in amplifiers (or an audio amplifier with rear
loudspeakers).
Connect the audio cables to the rear loudspeakers and to the Dolby
AUDIO surround output S at the back of your TV as shown opposite.
S
There is only one cinch output for both speakers. Use a mono to stereo
adaptor.
Note: Switch off the TV and the rear loudspeakers before connecting them.
Select
See Surround settings, p. 14 for the available Surround modes.
Rear Surround Sound loudspeakers should always be located behind or to
either side of the listener at about 1 m above the seated listener's head.
Adjust the volume of the rear loudspeakers.
You may make use of the Test tone function in the Surround settings menu,
see p. 13, to have a reference of the loudness of the separate loudspeakers.
Note: Once you have adjusted the volume of the rear loudspeakers, do not change it
while watching TV as the whole configuration operates with the volume
adjustment of your TV.
Dolby Pro Logic Surround amplifier
Connect the Dolby Pro Logic Surround amplifier to the
the back of your TV.
Select
The audio output is now independent of volume, equalizer and surround
settings.
Switch off the volume of the TV with the mute key
All volume settings, tone control and speaker connections have to be done
via the external Dolby Pro Logic amplifier.
Attention: the sound info on screen will not correspond with the actual sound
If you want to connect more equipment to your TV, consult your dealer.
and at the back of your TV.
R
Extra front speakers Yes (Amp)
in the Setup menu. See p. 7.
Rear speakers Yes
in the Setup menu. See p. 7.
Extra front speakers No
reproduction.
Connect Peripheral Equipment
in the Setup menu. See p. 7.
and
AUDIO L R
.
at
27