Table of Contents
Advertisement
2030.3 gb
22-05-2001 10:29 Pagina 14
Available menu items in case of the selected
and available Surround modes.
Surround settings
Test start
Test stop
Centre volume
Balance
Rear volume
3D effect
Surround mode
Surround settings
Test start
Test stop
Centre volume
Balance
Rear volume
3D effect
Surround mode
Use of the menus
14
14
With extra loudspeakers connected
The contents of the Surround settings menu depends on the extra
speakers/amplifiers connected and on the configuration settings selected in
the Setup menu. See Connect Peripheral Equipment, Extra loudspeakers, p. 27
•
•
•
and Install TV Setup, p. 7.
•
•
•
If no extra front or rear speakers are connected do not change the predefined
factory settings of Extra Front and Rear speakers.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Note: you can select only those surround modes which can be used with the
broadcasted signal.
The graphical representation of the speakers is displayed on screen when
controls are being changed or when in test tone mode.
The drawing on screen is updated according to the chosen setup and the
selected surround mode. Speakers which are active are highlighted.
In 3D surround mode the graphical representation of the rear loudspeakers is
replaced by the symbol ®r.The menu item 3D effect appears and the level
of the 3D effect can be adjusted.
With two extra rear surround loudspeakers connected
The menu item Test which only appears in Dolby 3 Stereo, 3D Surround
mode or Pro Logic, enables you to have a reference of the internal and the
rear loudspeakers loudness.
Select
Select
A steady noise tone is switched sequentially through the available
loudspeakers, for 2 seconds each.This enables you to have a reference of the
loudness of each loudspeaker.
The loudspeakers activated light up in the screen graphic.
Select
adjustments.
Select
adjustments of the speaker levels.
Dolby 3 Stereo
,
3D Surround
or
and press the OK key.
Test start
,
or
Centre volume
Balance
Rear volume
and press the OK key when you have finished the
Test stop
Pro Logic
.
and alter the selected
Advertisement
Table of Contents
