Zanussi DI 720 Instructions For The Use And Care page 31

Adjusting the door balance
Fitting the decor panel may sometimes
affect the door balance due to the
different load placed on the same. In this
case it will be necessary to adjust the
balance by regulating the appropriate
nuts «A» provided on the back of the
machine near the rear feet. By screwing or
unscrewing these nuts the tension of the
door balancing springs is increased or
decreased respectively (fig. 24).
Pro me plate assembly
(See fig. 25)
The program plate is fastened to the
control panel as follows:
1. Remove knob «A» from the
programme selector.
2. Remove screw «B» fastening the knob
body to the programme selector spindle.
3. Depress pushbuttons.
4. Position the programme plate on the
control panel taking care to introduce tags
«C» into corresponding slots provided on
the control panel. To lock them in position
press the programme plate against the
control panel.
5. Refit the knob assembly.