Table of Contents
Advertisement
Available languages
Available languages
Controls and indicators
Front side
Rear side
Upper side
ENGLISH
@)
Illumination
(Remote control sensor
@ How to use the VOLUME
CONTROL, TUR-
Receives the transmission from the remote control unit.
NOVER
switch, and PHASE switch
@POWER switch
The VOLUME CONTROL, TURNOVER switch, and PHASE
switch can be adjusted to match the condition of the listening
Press to switch the
power to the Super Woofer ON and OFF.
P
room
and/or the characteristics of the ieft and right front
@TURNOVER switch
anuckate.
Set according to the woofer size of the front speakers used
When the TURNOVER switch is set to the 90 Hz or 120 Hz
in combination with the Super Woofer. Before switching this
position, it is recommended
to install the Super Woofer be-
switch, set the VOLUME CONTROL to the minimum position.
tween the left and right speakers to obtain a better sound field
(@)SUPER SUBSONIC BASS switch
effect.
Turning this switch to ON obtains more effective low and
heavy sound.
()PHASE switch
This switch is used to switch the speaker sound phase to
vary the tonal quality of the bass.
©®BASS BOOST
switch
Press (to ON) to boost the bass effect.
@VOLUME
CONTROL
Adjusts the volume level of the ultra-bass output of the Su-
per Woofer.
Rotating the knob clockwise increases the
volume
level, and rotating the knob counterclockwise
therefore be paid to the following precautions.
decreases the volume level.
Nite:
(ILLUMINATION
switch
1. Do not increase the output of the amplifier to a high level while
Press (to ON) to switch on the illumination.
the low-frequency level is enhanced by the amplifier's tone con-
trol or loudness control.
Typical Control Positions
Crux
[ase [vou]
Large speaker
NORMAL
OQ
Medium speaker
NORMAL
©
@ Caution concerning operation
An excessive input level to the Super Woofer may spoil the
sound quality or damage the unit. Careful attention should
'© LIGHT
CONTROL
2. When operating the amplifier switches or when placing the stylus
Adjusts the illumination level. When this conirol is turned
on an analog record, set the amplifier volume to its minimum
clockwise, the illumination becomes brighter. When this
level.
control is turned counterclockwise, the illumination becomes
darker.
Duct
The ultra-bass output of the Super Woofer is output from
this duct.
@)INPUT (RCA-type
pin-plug) jack
STAND BY mode of POWER key
These jacks are used to connect the Super Woofer Pre-Out
oe
pages mi as Ole eee
eee
jacks of the amplifier or the supplied adaptor.
-
'
g
Pp
reg
of the ON/OFF setting of the POWER key. This indicates
(Power cord
that a small amount of current is being supplied to the
Connect to a 110 —
120 V or 220 , 240 V AC power
unit to back up the memory contents and support the
outlet.
timer function. This mode is referred to as the Stand By
:
mode. While the STAND BY indicator is lit, the power
Keane
rh saieid ewitcn
of the system can be switched ON/OFF from the remote
:
control unit.
8 sw-700 (En)
Advertisement
Table of Contents
