Clamping Wide Workpieces; Supporting Long Workpieces - Delta 26-2312 Instruction Manual

CLAMPING WIDE WORKPIECES

See Figure 27.
1.
When cutting wide work pieces, such as 2 X 12 inch,
clamp the workpiece to the work table using a work
clamp .
PC3
KEEP clamps away from the path of the
blade and blade guard assembly.

SUPPORTING LONG WORKPIECES

See Figure 28.
1.
In most cases the included table extensions (workpiece
supports) will be sufficient to support longer workpieces.
If these are not long enough, the workpiece should be
supported further out from the saw. Additional support
may be used to make the workpiece lay flat on the
A
saw table. Use the included work clamp or a C-clamp
to secure the workpiece to the miter saw table.
B
OPERATION
PC3
23
Figure 27
B
A
Figure 28