Table of Contents
Advertisement
SLIDE RESISTANCE
See Figure 18.
The slide resistance (friction) on your saw is adjustable. Use a
4mm Hex wrench.
1.
Locate the glide adjustment screw
arms. Turn Clockwise to tighten the sliding friction.
2.
Turn Counterclockwise to loosen the sliding friction.
MITER LOCK ADJUSTMENT
See Figure 19.
If your saw's miter lock does not lock securely, you may be
required to tighten the miter lock adjustment. This adjustment
is located on the underside of the miter saw arm. To make
adjustments:
1.
First unlock the miter lock knob. Use a 10mm open
ended wrench to loosen (Counterclockwise) lock nut
while holding the adjustment rod
B
using another 10mm open end wrench.
2.
Turn the adjustment rod in order to tighten/loosen the
miter lock.
3.
Lock/Unlock the miter lock knob to check the miter lock
adjustment.
4.
Once you have set your miter lock adjustment
re-tighten the lock nut
from loosening over time.
ALWAYS check to make sure the miter lock
is locked tightly into position before using your saw. Failure to
follow these instructions could result in serious personal injury
due to the miter lock slipping during use of the saw.
ADJUSTMENTS
on the saw
A
in place
C
to prevent this adjustment
B
A
Figure 18
Figure 19
18
LOOSEN
TIGHTEN
LOCK
UNLOCK
C
B
Advertisement
Table of Contents
