Using Your New Tv; Setting Up The Tv Automatically - Sony Trinitron KV-20V80 Operating Instructions Manual

Using your New TV
Setting up the TV automatically
The Easy Setup Guide allows you to set the
on-screen language and set all receivable
channels. The Easy Setup Guide screen
appears every time you turn on the TV until
you perform AUTO PROGRAM.
The Easy Setup Guide feature does not apply for
installations that use a cable box for all channel
selection.
To set up the TV manually, refer to "Using the
SET UP menu" on page 23.
Tips
© Perform this function during the day, with the antenna +
andjor cable properly connected, to ensure that all available
channels will be broadcasting and recetvable.
© After using the Easy Setup Guide you will still have the
option of adjusting any of the system settings, like skipping
channels, through the SET UP menu (page 24).
© The TV must.be set fo the TV input to execute AUTO
PROGRAM. Press ANT until a channel number appears.
* If your cable or antenna is connected to AUX, then
press ANT until AUX appears next to the channel
number. (KV-27565, 27V65 only)
Using the buttons on the front of the TV:
SETUP TY SISFO VON EME RANKES POWER
oOUD EDU
For KV-27V65, the control buttons are located
on the top of the TV.
1 Press POWER to turn on the TV.
The Easy Setup Guide screen appears.
POWER
(CH+}
(CH-}
AUTO SET UP: [VOL+)
DEMO: (VOL~}
First Please connect
cable/antenna.
Press (SETUPIto exit
2 (except Canadian models)
Press CH + to select English screens or
CH — to select Spanish screens.
— CHANNEL +
an
2
»
3 Press VOL + tocontinue or VOL - fora
DEMO of functions and menus.
— VOLUME +
AUTO PROGRAM
AUTO PROGRAM appears and the TV
starts scanning and presetting channels
automatically. When all the receivable
channels are stored, the lowest numbered
channel is displayed. If the TV receives
cable TV channels, CABLE is set ON
automatically.
To perform AUTO SET UP again
¢ Press SET UP on the TV.
¢ PressCH + or CH - toselect a language.
* Press VOL + to restore factory settings
(CONTINUE TO AUTO PROGRAM? will
appear on the screen). Press CH + to
continue or CH - to exit.
e Press SET UP to exit.
Note
¢ When you perform AUTO PROGRAM,
your CHANNEL FIX, CHANNEL BLOCK
and ON/OFF TIMER settings will be
erased.
13