Operation Control; Temperature Selection - Danby DAR195W Owner's Manual

Operation Control
The temperature of the refrigerator is controlled by
setting thermostat knob, (ceiling of the cabinet) to a
desired setting.
Temperature Selection
To start the refrigerator, turn the temperature control
knob to the position corresponding to the desired
cooling ( on the graduated blue dial)
Fig A
The refrigerator temperature will vary depending on
the quantity of the food stored and on the frequency
with which the door is opened.
To turn the control to the "OFF" position, rotate the
control knob to the "0" position. If the refrigerator has
been left out of use for some time, set the control to
maximum for 2-3 hours before turning to the desired
position. If the refrigerator is not being used for long
time periods, disconnect the plug and leave the door
partially open. This will help to reduce mold/mildew
from accumulating inside the refrigerator cabinet.
• Changes in ambient room temperature will affect
internal refrigerator temperatures (choose correct
setting of the thermostat knob).
• In STOP (0) position the appliance does not operate
(cooling system is switched off), yet power supply is
not interrupted (the light is on , when you open the
refrigerator door).
• Temperature in the refrigerator also depends on
how often the door is opened.
6
DAR195W/0L