Kenwood KA-5200 Instruction Manual page 11

OPERATING INSTRUCTIONS
PHONO OPERATION
1. Set the SELECTOR switch to PHONO.
2. Set the MODE switch to STEREO and the TAPE MONITOR
switches to off (by button release).
Adjust the VOLUME to the desired listening level.
4. Use the BASS, TREBLE, FILTER and LOUDNESS controls
to adjust the sound to your preference and to the acoustic condi
tions of the room.
w
TAPE RECORDER OPERATION
TAPE MONITORING
If you wish to use the KR-5200 with 3-head type tape recorders,
you can perform a sound quality check by momentarily comparing
the recording source signal with the sound that has been recorded on
the tape. If you push the TAPE MONITOR switch, the recorded sound
is reproduced. If this switch is released, the source signal before record-
ing can be reproduced.
WHEN USING ONLY ONE TAPE RECORDER
Connect the tape recorder to either the A TAPE jacks on the rear
panel or B TAPE jacks on the front panel.
Recording
1. Set the SELECTOR switch to the desired program source.
For recording with tape recorder A, switch off TAPE MONITOR
B (by button release}. For recording with tape recorder B, TAPE
MONITOR A should be switched off. To monitor the recording,
push the corresponding TAPE MONITOR button.
3. Recording level should be adjusted with the volume control of
your tape recorder.
4. Recording is not affected by the VOLUME, BASS, TREBLE,
FILTER, LOUDNESS, etc., controls of the receiver.
Playback
1. The SELECTOR switch can be at any position.
2. Push the corresponding TAPE MONITOR switch. Make sure the
unused TAPE MONITOR switch has been switched off (by button
release).
3. Set the MODE switch to STEREO.
4. Adjust volume and tone quality.
WHEN USING TWO TAPE RECORDERS
Connect one tape recorder to A TAPE jacks on the rear panel and
the other to B TAPE jacks on the front panel.
For Simultaneous Recording with Two Recorders
1. Set the SELECTOR switch to the desired program source.
2. Switch off the A TAPE MONITOR (by button release).
Recording can be made into the two tape recorders simultaneously.
In this case tape recorder A cannot be monitored, but monitoring
is possible for tape recorder B.
3. Recording levels should be adjusted exactly as described previously
for single tape recorder operation.
For Recording from Tape Recorder A to B
1. Press the A TAPE MONITOR switch.
2. The SELECTOR switch can be at any position.
3. Set tape recorder A for reproduction and tape recorder B for
recording. The playback from the tape recorder A can then be
recorded on tape recorder B.
4. To monitor the recording condition, push the B TAPE MONITOR
switch.
1 Plug a microphone into the MIC jack on the front panel.
2. Set the SELECTOR switch to MIC.
3. Set the MODE switch to STEREO.
4. Adjust volume and tone quality.
i