Kenwood KA-5200 Instruction Manual page 10

OPERATING INSTRUCTIONS
FM RECEPTION
NOD
Set the SELECTOR switch to FM position.
Set the MODE switch to STEREO and the TAPE MONITOR
switches to off (by button release). To suppress interstation noise
push the FM MUTING switch, however, this should be left off if
the incoming signal is weak.
Tune in the desired station by turning the TUNING knob.
The station has been properly tuned in when the pointer of the
TUNING meter indicates a maximum deflection.
The STEREO lamp Sights up automatically when an FM stereo
station is tuned in. Set the MODE switch to MIX_ if the received
FM stereo signal is weak in relation to the noise level.
Adjust VOLUME to the desired listening level.
Adjust the balance of the left and right channels.
Use the BASS, TREBLE, LOUDNESS and FILTER to adjust
the sound to suit your own taste, as well as the acoustic conditions
of the room.
AM RECEPTION
1.
2.
3.
Set the SELECTOR switch to AM.
Set the MODE switch to STEREO and the TAPE MONITOR
switches to off (by button release).
Tune in the desired station by turning the TUNING knob. Tuning
is satisfactory when the pointer of the TUNING meter indicates
a maximum deflection.
Adjust the VOLUME to the desired listening level.
Use the BASS, TREBLE, FILTER, and LOUDNESS controls to
adjust the sound to your own taste and to the acoustic conditions
of the room.