Table of Contents
Advertisement
[10] USER SET
Pressing the USER SET selector [10] (the corresponding led lights), 18 Sound Effects sounds will be available,
they represent the USER SET.
The USER SET can be programmed by the User.
Pedal no.
MIDI note
Drums instruments
0
F#
7 102
Birds
1
E
7 100
Dog
2
G
5 79
Heartbeat
3
A
5 81
Footstep 2
4
B
5 &
Creaking
5
C
6 84
Door
6
C#
6 85
Scratch
7
D#
6 87
Engine
8
E
6 88
Car stop
9
F
6 89
Car pass
A
G
6 91
Siren
B
C
7 96
Pistol
Cc
A
7 105
Wind
PROGRAMMING THE USER SET
Follow this procedure to program the USER SET:
— Connect the MIDI OUT of your keyboard (PRO-E, E-80, etc.) to the MIDI IN of the PK-5.
— Select the same MIDI channel in the keyboard and the PK-5 (MIDI channel no. 11).
Select the SOUND EFFECTS pedalboard mode [7] in the PK-5.
— Press and hold for two seconds the USER SET selector [10]; after that, the corresponding led will begin to flash,
showing that the instrument is in ready condition for programming.
:
— Press and hold (from your keyboard), the Sound Effects notes you wish to memorize into the USER SET.
— Press (on the PK-5) the pedal into which you wish to memorize the Sound Effects notes.
At this point release the note played from your keyboard.
All the leds of the pedalboard will light simultaneously for a second, confirming that the programming has been
effected.
Repeat the procedure for programming the whole USER SET.
(11] MIDI CHANNEL
To select the MIDI Channels (1-16), press the MIDI CHANNEL selector [11]: the corresponding led will light.
By pressing the pedals, compose the number of the MIDI channel you wish to send (e.g. to send the MIDI channel
no. 16, press the pedals no. 1 and 6 in sequence). Then press the pedal marked by «B» letter (ENTER) to confirm
the operation. The leds of the pedalboard will light simultaneously for a second, confirming that the selection has
been made.
If a number is erroneously selected, press the pedal marked by «A» letter (CANCEL), to cancel the operation.
If you wish to select the default MIDI channel (the number 11 when in SOUND EFFECTS condition), simply press
the MIDI CHANNEL selector [11] and the pedal marked by «C» letter (DEFAULT).
The leds of the pedalboard will light simultaneously for a second confirming that the selection has been made.
If a MIDI channel number higher than 16 is erroneously selected, the pedalboard will exit automatically this func-
tion when the «B» pedal (ENTER) is pressed.
15
Advertisement
Table of Contents
