Roland PK-5 Owner's Manual page 2

Dynamic midi pedal

Hide thumbs

Table Of Contents

Table of Contents

For West Germany

Bescheinigung des Herstellers/Importeurs

Hiermit wird bescheinigt. daB der/die/das

in Ubereinstimmung mit den Bestimmungen der

Roland PK-5 Dynamic MIDI Pedal

Amtsbl. Vig 1046/1984

(Gerat. Typ. Bezeichnung)

(Amtsblattverfugung)

funk-entstort ist.

Der Deutschen Bundespost wurde das Inverkehrbringen dieses Gerates angezeigt und die Berechtigung zur Uberpriitung

der Serie auf Einhaltung der Bestimmungen eingeraumt.

Roland Corporation Osaka/Japan

Name des Herstellers/Importeurs

For the USA

RADIO AND TELEVISION INTERFERENCE

WARNING =

= This equipment has been verified to comply with the limits for a Class B computing device. pursuant to Subpart J. of Part 15. of FCC rules. Operation with

non-certified or non-verified equipment ts likely to result in interference to radio and TV reception.

The equipment described in this manual generates and uses radio frequency energy. If it is not installed and used properly. that is. in strict accordance with our instructions,

it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B camputing device in accordance

with the specifications in Subpart J. of Part 15, of FCC Rules. These rules are designed to provide reasonable protection against such a interference in a rasidential installation

However. there is no guarantee that the interference will not occur in a particular installation

If this equipment does cause interference to radio or television reception. which

can be determined by turning the equipment on and off. the user is encouraged to try to correct the interference by the following measure

® Disconnect other devices and their input output cables one at a time. If the interference stops. it 1s caused by either the other device or its 1'O cable

These devices usually require Roland designated shielded 1/O cables. For Roland devices. you can obtain the proper shielded cable from your dealer. For non Rojand

devices. contact the manufacturer or dealer for assistance.

It your equipment does cause interference to radio or television reception.

you can try to correct the interference by using one or more of the following measures

Turn the TV or radio antenna until the interference stops

Move the equipment to one side or the other of the TV or radio

Move the equipment farther away from the TV or radio

Plug the equipment into an outlet that is on a different circuit than the TV or radio. (That is. make certain the equipment and the radio or television set are on circuits con-

trolled by different circuit breakers or fuses.)

Consider installing a rooftop television antenna with coaxial cable lead-in between the antenna and TV. ff necessary.

you should consult your dealer or an experienced

tadioNelevision technician tor additional suggestions. You may find helpful the following booklet prepared by the Federal Communications Commission

"How to Identify and Resolve Radio — TV Interference Problems"

This booklet 1s available from the U.S. Government Printing Office. Washington. D.C., 20402. Stock No. 004-000-00345-4

For Canada -

etait

CLASS B

NOTICE

This digital apparatus does not exceed the Class B limits for radio noise emissions set out in the Radio Interference

Cet appareil numérique ne dépasse pas les limites de la classe B au niveau des émissions de bruits raclioélectriques fixés