Auxiliary Dc Connectors; Sidestand - Yamaha XSR900P Owner's Manual

Instrument and control functions
tains highly pressurized nitrogen
1
gas. Read and understand the fol-
lowing information before handling
2
the shock absorber assembly.

Do not tamper with or attempt to
3
open the cylinder assembly.

Do not subject the shock ab-
4 sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
5
plode due to excessive gas
pressure.
6

Do not deform or damage the
cylinder in any way. Cylinder
7
damage will result in poor
damping performance.
8

Do not dispose of a damaged or
worn-out shock absorber as-
9
sembly yourself. Take the shock
absorber assembly to a Yamaha
10
dealer for any service.
11
12
13

Auxiliary DC connectors

This vehicle is equipped with an auxilia-
ry DC connector and a grip warmer DC
connector. Consult your Yamaha deal-
er before installing any accessories.
5-29
EAU77390

Sidestand

The sidestand is located on the left side
of the frame. Raise the sidestand or
lower it with your foot while holding the
vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system, which
cuts the ignition in certain situations.
(See the following section for an expla-
nation of the ignition circuit cut-off sys-
tem.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the sides-
tand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
this system regularly and have a
EAU15306
EWA10242