Operation; Receive; Transmit - Kenwood TH-225A Instruction Manual

© BEEP key: then 2/BEEP
Each time these keys are pressed, the audio annunciator will
be turned ON or OFF alternately.
© (FREQUENCY) STEP key: then 3/STEP
Each time these keys are pressed, the frequency scanning
step size will be increased 5 kHz.
Several different scan function keys and scan stop keys are
provided.
© BAND SCAN key: [-_] then 4/BAND
@ MEMORY SCAN key: then 5/MEMORY
@ PROGRAMMABLE BAND SCAN key: [Z] then
6/PROGRAM
@ SEEK OPERATED SCAN key: [-_] then 7/SEEK
@ TIME OPERATED SCAN key: [_] then 8/TIME
© CARRIER OPERATED SCAN key:[-_] then 9/CARRIER
For additional information on this function refer to page 14.
©@ TX. STOP key: then M/TX. STOP
Pressing these keys will prevent accidental transmission.
To cancell this function, press these keys again.
© KEY LOCK key: [E] then ENTER/KEY LOCK
To cancel this function, press these keys again.
© FAST [7] key: then V/FAST
© FAST [{] key: then A/FAST
© LOCK OUT key: then 0/L.OUT
Each time these keys are pressed, the Memory channel lock
out function will be turned ON or OFF.
10
OPERATION
@ RECEIVE
set the switches as follows:
4. Enter the desired frequency.
@ TRANSMIT
CAUTION:
Long transmission or extended operation in the 6 watt mode might
cause the rear of this transceiver to get warm. Do not place the
transceiver where the heat sink (rear panel) might come in contact
with plastic or vinyl surfaces.