Table of Contents
Advertisement
Connection of videodisc player
Video-path — Connect the VDP VIDEO jack of this unit and
the video output jack of the videodisc player with an
audio cable.
Audio-path — Connect the VDP AUDIO jacks of this unit
and the audio output jacks of the videodisc player with an
audio cable.
Videodise player
Ch
EE
QO.
cgoo0ononDD
OO
Video-path connection
Audio-path connection
Videodisc connection
Note:
1. In sorne video deck, connecting the plug into the REC jack auto-
matically shut off the built-in TV tuner section of the video deck.
For details of the connection, refer to the Instruction Manual of
the video deck.
2. When connecting a monaural video deck, set the MODE switch
to MONO.
Connection of TV sets
@ With conventional TV sets (having no video
input jack)
1. Connect the VHF antenna output terminal of the video
deck connected to the VCR A jacks and the VHF IN ter-
minal of this unit with the supplied coaxial cable.
2. Connect the VHF OUT terminal of this unit and the VHF
antenna
input terminal of the TV set with the coaxial
cable supplied with the video deck.
3. Connect the UHF antenna input terminal of the TV set
and the UHF antenna output terminal of the video deck
with a UHF ribboned feeder lead. For proper connection,
consult the Instruction Manual of your video deck,
ae
TV antenna
Conventional TV set
UHF
-
To VHF output
To VHF antenna
terminal
terminal
Using conventional TV set
@ With monitor TV or conventional TV equipped
with the video input jack
As shown in figure below connect the VIDEO OUT jack of
this unit and the video input jack of the TV set with an audio
cable.
Audio cable equipped with
pin plug on each end
Monitor TV set
Monitor TV connection
RF converter setting
The built-in RF converter converts signals played back from
video equipment connected
to the KVC-470
into signals
used in TV broadcasting.
The converted signal is transmit-
ted to the vacant channel of the TV set connected to the
KVC-470 for video reproduction.
For this purpose, set the
RF converter switch to the vacant channel, 3 or 4, according
to your location.
RF converter setting
Connection of amplifier
Connect the tape input jacks of the amplifier to the AUDIO
OUTPUT jacks of this unit with an audio cable. Connect the
tape output jacks of the amplifier to the AUDIO INPUT jacks
of this unit with an audio cable.
Connection of tape deck
Connect the line in jacks of the tape deck.to the TAPE REC
jacks of this unit with an audio cable. Connect the line out
jacks of the tape deck to the TAPE PLAY jacks of this unit
with an audio cable.
Kvc-470 (U) 5
Advertisement
Table of Contents
