Kenwood KE-7090 Instruction Manual page 8

KE-7090 [En)
Make connection as shown below. When connecting the
related system components, refer also to the instruction
manuals of the related components.
Caution: Do not plug in the power lead until all connections
are completed.
{ Except for U.S.A., Canada }
Caution regarding placement
Malfunction of microprocessor }
ds If operation is not possible or erroneous display appears even
though all connections have been made properly, reset the
microprocessor referring to "In case of difficulty".
— (24)
ese aes ean
To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than,
shown below.
Left and right panels: 10 cm, rear panel: 10 cm
Amplifier or receiver with the TAPE MONITOR switch
SYSTEM
CONTROL
freee a
*Caution ( For U.K.)
Whenusing the AC outlets equipped
with this unit, be sure to consult
your dealer for the corresponding
plug.
Connect to the TAPE jacks
(TAPE MONITOR)
(Set the TAPE MONITOR switch
to the monitoring position.) U.K.
China i
System contro! cord
Other countries
SYSTEM CONTROL
GUB)
{XSB)
oI
=
See:
Audio cords
G:
IN
OUT
This unit
Audio cords
To wall AC outlet
SYSTEM CONTROL
Set the system con-
trol mode according to
the components to be
connected.
UNE IN LINE OUT Sas OeeeQ aoa
e@When connecting the audio cords (cords with pin plugs on each end), insert
the white plugs into the [L] (Left) jacks and red plugs into the [R] (Right) jacks.
2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outiet. Plugging/unplugging connection
cords without removai of the power cord can cause malfunctions or damage on the unit.
3. Do not connect up a power source which is larger than that indicated on the socket at the rear of the unit.
as 1. Connect all cords firmly. If connections are joose there could be loss of sound or noise produced.
Notes