Using А Monitor Memory - Radio Shack DX-394 Owner's Manual

Memory Tuning
For easy selection, you can store the fre-
'quencies of your favorite stations into
memory channels. You can store up to
160 frequencies — 10 Irequoncies each in
the LW, MW, SW bands, and 10 in each of
the meter bands.
^. Select the band or meter.
2. Use direct access or manual tuning to
lune to the frequency you want to
store.
Note: When you store frequencies in
the SW band and the meter bands, tho
irequoncias aro stored in ether the
SW band's channel mamory or tho
moter bande chanai memory
depending on the tuning method
When a frequency (or example
3,200000 MHz, 00m) la tunad by direct
tuning (using FREQ), the troque
stored in thw SW bands cha
'memory. When the same frequency є
tuned by manual tuning (using the tu-
ning control or or Y), the frecuency
is stored in tho 90m band's channel
memory.
3. Pross pam.
4, While Рам CH flashes, enter a me-
mory channel number tom 1-10
(prese o for 10).
5. While Рам си and the memory chan-
nel number flash, press ENT to store
the frequency.
Note: I! you wait more than 10 se-
conds to press ENT, you must begin
again кот Step 3
6 To store more frocuencies in the same
band, repeat Steps 2-5. To store a 're:
'quency from another band, repeat
Steps 1-5.
To tune lo the desired memory channel
Select the band and then press tho chan-
nel number.
USING A MONITOR MEMORY
Tne receiver's monitor memory ie a tom-
porary storage area whore you can storo
a frequency while you decide whether or
not 1o save it in u channel,
1. Press MON while the desiec tro-
'quency is displayod. mow ard any pre-
viousy stored frequency appear on
the display
2. Press ENT. Tha new frequency
replaces the od ore in the montor
memory
To listen tc the moriter memory, oress
17