Starting/Stoppiog Instructions - Ryobi 700r Operator's Manual

(_1_ AUTION: This model is a non-
clutch unit. At idle the trimming
line co_InueS to rotate.
1. MIX OIL WITH GAS AND FILL FUEL TANK
WITH FUEL/OIL MIXTURE per Instructions
on page 9.
2. Put the IGNITION SWITCH IN THE "ON"
POSITION (Fig. 6).
3. FULLY PRESS AND RELEASE THE PRIMER
BULB 8 TO 7 TIMES, FUEL SHOULD BE
VISIBLE IN THE BULB (Fig. 7).
4, PLACE THE CHOKE LEVER IN THE FULL
uCHOKE" POSITION (A) (F_. 8),
5. WITH THE UNIT ON THE GROUND,
SQUEEZE THE THROI"rLE TRIGGER
FULLY AND PULL THE STARTER HOPE
BRISKLY (Fig, 9) untll the engine sounds
like it wants to run (normally2 to 5 puffs).
NOTE: Keep the throttle trigger depressed at aft
times untilthe engine is wanned up.
6, PLACE THE CHOKE LEVER IN THE
"PARTIAL" CHOKE POSITION (B) (Fig. 8).
7, PULL THE STARTER ROPE BRISKLY 1 TO
3 TIMES TO START THE ENGINE (Fig. 9).
8. If the engine does not start, repeat steps 4
through 7,
NOTE: If the engine floods while attempting to
start the unit, place the choke [ever in the
"RUN" posiflon (C), squeeze the throttle
trigger, and pull the starter rope briskly.
The angina should statt _V_t _n thee (3) to
eight (8) pulls,
9. Attar the angina weJ'rnsup for 5 to 10
seconds, PLACE THE CHOKE LEVER IN
THE "RUN" POSITION (C) (Fig, 8). Be sure
to keep throttle trigger depressed while
warming up engine,
NOTE: Choking is not required when starting a
warm engine, Start a warm engine in the
"PARTIAL" CHOKE POSITION (B).
10. To stop the engine, put the IGNITION SWITCH
IN THE "(WF" POSITION (Fig.6),
Switch
Rg. 6
Cap
Pug
Choke
Position\
_)
Partial
Choke
Position
(13)
Fig. 7
Choke Lever
Run
Position
" (C)
r_k, H P,I Ill
,\
Screw
Fig, B
Starter
Rope
ThmNie "lHgger
Fig. 9
10