Adjust Unit To Track Straight - Ariens IKON XD 42 Operator's Manual

2
1
1. Adjusting Hole
2. Mounting Hole
3. Steering Lever
4. Upper Control Arm
Figure 34
See Figure 35.
1. Loosen lock nut on height-adjustment
bolt.
2. Turn bolt in or out until levers are at the
same height.
3. Tighten lock nut.
1
1. Lock Nut
2. Height-adjuster Bolt
Figure 35
Adjust Steering Level Reach
See Figure 36.
1. Loosen hardware securing steering lever
4
2. Pivot steering lever to desired position.
3. Ensure levers are aligned with each
4. Tighten hardware.
3
1. Steering Lever
2. Upper Control Arm
3. Hardware
ADJUST UNIT TO TRACK
STRAIGHT
Check Tire Pressure
1. Check pressure of both tires. See
2. Recheck unit tracking. If unit still does not
2
IMPORTANT: DO NOT exceed maximum tire
pressure listed on tire sidewall.
If increasing tire pressure on one side does
not correct tracking problem, adjust the
steering levers.
EN - 25
to upper control arm.
other.
3
Figure 36
Specifications on page 33 for
recommended tire pressure.
track straight, note which side the unit
pulls toward and increase the
tirepressure on that side.
1
2