Table of Contents
Advertisement
PROBLEM, CAUSE, SOLUTION CHART
PROBLEM
CAUSE
SOLUTION
Removable Filter Needs
Filter is not placed in
Make sure Removable filter is seated properly under wash
Frequent Cleaning
dishwasher correctly
arm. See page 23.
Spray nozzle on wash arm is | Remove lower wash arm— see page 23—and turn upside
blocked
down. Cii under side of each tube is an indentation. In one of
Dishes not scraped before
loading
these indentations is a nozzle (hole) which cleans filter.
Check to make sure the nozzle is not blocked.
Make sure leftover food, bones, toothpicks and other hard
items are scraped from dinnerware before loading.
To Remove Spots and Film:
To remove spots and film on dish-
ware and glasses, or hard water
film on the interior of the dish-
washer, you may want to use strip-
ping products such as LIME-A-
WAY or GLASS MAGIC. These
products are available in the deter-
gent section of your local grocery
store; follow the manufacturers'
directions.
Or you may use vinegar with the
following procedure:
1. Load clean dishes and glasses
in dishwasher in regular manner.
Do not load silverware or other
metals in the dishwasher.
2. Close and latch door and select
LIGHT/CHINA WASH CYCLE.
Do not use detergent. Allow
dishwasher to run through the
26
first wash. When washer has
filled for main wash portion of
cycle, unlatch and open door.
Add 2 cups of household vine-
gar. Close and latch door and re-
select LIGHT/CHINA WASH
CYCLE.
3. After final rinse water has
drained, cancel cycle. Do not
allow dishwasher to go through
dry portion of cycle.
4. For a final polish, put two table-
spoons of non-precipitating type
water conditioner (such as CAL-
GON) in the right-hand Main
Wash compartment of detergent
dispenser, and run dishwasher
through complete LIGHT/CHINA
WASH CYCLE.
Advertisement
Table of Contents
