Radio Operation - Emerson EPB-3004 User Manual

Notes:
1) Charging time will vary if you are listening to music while charging the internal
battery. We recommend you place the unit in Power off mode during the charging
process or until EPB-3004 batteries are fully charged.
2) To prolong the life of a rechargeable battery, it is recommended to completely
discharge it before fully charging it again.
3) Rechargeable batteries need to be cycled for maximum performance and longer
battery life. If you don't use the player that often, be sure to recharge the battery at
least once a month in order to keep the internal battery working properly.
Battery Note and Care
• Do not burn or bury batteries.
• Do not puncture or crush.
• Do not disassemble.
• Recycle Lithium batteries. Do not dispose of in the trash.
• Charge batteries on a fireproof surface away from flammable items or liquids.
• Batteries should NEVER be left unattended while charging. Only adults should charge the
batteries.
• Follow the manufacturer's instructions for charging the product and do not charge longer
than recommended. Unplug the AC power cord when the battery is charged or not in use.
NOTE: These speakers are not magnetically shielded and may cause color distortion on the
screen of some TVs or video monitors. To avoid this, you may need to move the speakers
further away from the TV or monitor if unnatural color shifts or image distortion occurs.
1. Slide the FUNCTION switch to RADIO position, the unit will be "On" and power LED
indicator lights.
2. Select the desired FM mode by switching the FM/FM ST. BAND SELECTOR on unit top
panel.
3. Tune to your desired station with the TUNING knob. If FM STEREO mode is selected and
you tune to an FM Stereo station, the FM STEREO LED Indicator will light.
4. Adjust the MASTER VOLUME knob to obtain the desired sound level.
FM & FM-STEREO RECEPTION
● Set the BAND SELECTOR to "FM" position. Stations will now be received in MONO mode.
When a FM station is weak or distorted, listening is usually improved by switching the band
selector to the FM (mono) position.
● Set the band selector to "FM-ST" position to receive stereo broadcasts. The FM-Stereo LED
indicator will light up to show a FM stereo station is detected.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak, change the position of the
unit until the internal antenna picks up the strongest signal.
FM - If a stereo broadcast program is being received, the FM STEREO INDICATOR will
light. During FM Stereo reception, always keep the FM TELESCOPIC ANTENNA fully
extended for best performance. However, if FM reception is weak, try repositioning the unit
near an open window until you get the best reception.

RADIO OPERATION

7