Table of Contents
Advertisement
@ SCAN OPERATION
1
Memory Scan
Program scan
1270.00
&
1260.00 1299. 98(VFO-A)
1299.99(VFO-B)
3 |Rapid Advance
|
_ _ _ |
The radio will advance to the next channel,
Before initiating scan operation, adjust the SQUELCH control to the ''Threshold Point'',
or scanning furictions will not operate properly.
1 | Scan start
The MS annunciator will light, and scan will
proceed from channel 1 thru channel 5.....
a
Memory channels without data will not be
scanned.
Function ©
The BUSY indicator will light, and scan will
stop, when a signal is received. Scan will
resume when the carrier drops out.
i
even if a signal is present.
4 | Scan Release
or Mic PTT | The unit will revert to MR mode.
switch
Note:
To resume scan first press the [C] key to return to VFO operation. Scan can
;
only be started from VFO mode.
;
Since all memory channels are cleared when the reset switch is pressed, an
error alarm will sound-if you try to scan an empty memory bank.
1)
When the VFO is at point ''a'', scan will proceed as follows:
R
T
UP scan
DWN scan
2)
DWN scan
17
Advertisement
Table of Contents
