Table of Contents
Advertisement
OL
Teletext
Teletext is an information service transmitted by most TV stations. The index page of the
teletext service (usually page 100) gives you information on how to use the service. To
operate teletext, use the remote control buttons as indicated below.
iN Make sure to use a channel (TV Broadcast) with a strong signal, otherwise teletext errors
may occur.
To Switch On Teletext :
After select the channel (TV Broadcast) which carries the teletext you wish
to view, press ©).
To Select a Teletext page:
Input 3 digits for the page number, using the numbered buttons.
© If you have made a mistake, retype the correct page number.
© If the counter on the screen continues searching, it is because this page is not available. In that case,
input another page mumber
To access the next or preceding page:
Press PROGR + ( Ga)) or PROGR - (€)).
To superimpose teletext on to the TV:
Whilst you are viewing teletext, press ©). Press it again to cancel teletext mode.
To freeze a teletext page:
Some teletext pages have sub-pages which follow on automatically. To stop them, press
©) /@). Press it again to cancel the freeze.
To reveal concealed information (e.g: answer to a quiz):
Press ()/() . Press it again to conceal the information.
To Switch Off Teletext:
Press ().
Fastext
Fastext service lets you access pages with one button push.
While you are in Teletext mode and Fastext is broadcast, a colour coded menu appears at
the bottom of the teletext page. Press the colour button (red, green, yellow or blue) to access
the corresponding page.
Connecting Optional Equipment
Using the following instructions, you can connect a wide range of optional equipment to
your TV set. (Connecting cables are not supplied).
S VHS/Hi8/
DVC
camcorder
VCR
LZ
Decoder
8mm/Hi8/DVC
camcorder
** "PlayStation" is a product of Sony Computer
Entertainment, Inc.
»* "PlayStation" is a trademark of Sony
Computer Entertainment, Inc.
thee
"PlayStation" *
Decoder
Connecting a VCR:
To connect a VCR, please refer to the section "Connecting the aerial and VCR" of this instruction
manual. We recommend you connect your VCR using a scart lead. If you do not have a scart
lead, tune in the VCR test signal to TV programme number "0" by using "Manual Programme
Preset" option. (for details how to manual programme, see page 13, step a).
Also refer to your VCR instruction manual to find out how to find the output channel of your
VCR.
Connecting a VCR that supports Smartlink:
@
Smartlink is a direct link between the TV set and the VCR. For more information on
Smartlink, please refer to the instruction manual of your VCR.
lf you use a VCR that supports Smartlink, please connect the VCR by using a Scart lead to
the Scart @2/-3 J.
If you have connected a decoder to a VCR which supports Smartlink
feature:
Select the "Manual Programme Preset" option in the "Set Up" menu and after entering in the
"Decoder" option, select "On" (by using W or 4). Repeat this option for each scrambling
signal.
*This option is only available depending on the country you have selected in the "Country"
menu.
:
continued...
Advertisement
Table of Contents
