Table of Contents
Advertisement
9.7. Turntable Motor
1. Remove the motor cover by breaking off at the 8 spots indicated
by the arrows.
2. Disconnect the two lead wires connected to the turntable motor
3. Remove the turntable motor by removing the two screws
Note: After breaking off the motor cover, make sure that cut-off portions are properly trimmed
off or bent inside so that no sharp edges are exposed.
Note: To secure the motor cover use a 4 x 6 screw.
Disassembly of the door
Figure 8
Removing the Turntable motor cover
Figure 9
26
Advertisement
Table of Contents
Troubleshooting
