Table of Contents
Advertisement
Configure the memory on die termination resistors' WR for channel A1.
ODT WR (B1)
Configure the memory on die termination resistors' WR for channel B1.
ODT NOM (A1)
Use this to change ODT (CH A1) Auto/Manual settings. The default is [Auto].
ODT NOM (B1)
Use this to change ODT (CH B1) Auto/Manual settings. The default is [Auto].
ODT PARK (A1)
Configure the memory on die termination resistors' PARK for channel A1.
ODT PARK (B1)
Configure the memory on die termination resistors' PARK for channel B1.
Advanced Setting
ASRock Timing Optimization
Configure the fast path through the MRC.
ASRock Second Timing Optimization
Configure the second fast path through the MRC.
Memory Training Mode
Configure the Training Memory Mode.
Realtime Memory Timing
Configure the realtime memory timings.
[Enabled] The system will allow performing realtime memory timing changes after
MRC_DONE.
Reset for MRC Failed
Reset system after MRC training is failed.
Train on Warm Boot
When enabled, memory training will be executed when warm boot.
MRC Fast Boot
46
Advertisement
Table of Contents
