Power Supply Assembly - Lenovo ThinkStation P7 User Manual

Removal steps
Note: When installing a new super capacitor module, connect the super capacitor module cable to the super
capacitor module connector (J14) on the RAID card.

Power supply assembly

Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Although there are no moving parts in the computer after the power cord has been disconnected, the
following warnings are required for your safety.
Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury, seek
medical care immediately. Never remove the cover on a power supply or any part that has the following label
attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label attached.
There are no serviceable parts inside these components. If you suspect a problem with one of these parts,
contact a service technician.
For access, please remove the side panel. See "Side panel" on page 39.
. 69
Chapter 5 CRU replacement