International Harvester Company INTERNATIONAL Cub Cadet 73 Operator's Manual page 34

LUBRICATION GUIDE
lfitern«tion«l Cub Cadet 106 and 126 Tractors
- After Every 10 Hours of Operation
1 — Oil filler cop and boyoneNtype
oil level gouge.
Check the oil (with the engine stopped) and add sufficient
new oil to bring it to the ''FULL'' mark on the gauge. Do
not overfill. Do not operate the engine if the oil level is
below the "LOW" mark on the gauge.
2 -- Steering knuckles (2).
3 - Front oxle pivot pin.
Use IH 251H EP grease or equivalent #2 multi-purpose
lithium grease and apply sufficient grease to flush out old
grease and dirt.
4 — Engine cronkcase.
- After Every 30 Hours of Operation
While the oil is warm» remove the drain plug (4) and drain
all of the oil from the crankcase. Replace the drain plug.
Remove the crankcase oil filler cap (1). Refill the crank-
case with new oil up to the "FULL" mark on the oil level
gauge. Refer to the "Lubrication Table" for the proper
quantity and viscosity to use.
S * Power toko'Off shaft beoring.
- After Every 150 Hours of Operation
Use IH 251H £P grease or equivalent #2 multi-purpose
lithium grease and apply two or three strokes of the lubri¬
cator to the lubrication fittings.
See II
lust.
15.
Tronsmission
6 • Oil level and filler plug.
7 Oil drain plug.
Creeper drive housing
6 - Level plug.
9 > Breother ond filler plug.
10 - Droln plug.
- Periodic
Check the oil level periodically* Keep the lubricant up to
the level plug (6) on the rear of the transmission case.
Change the oil in the transmission case at least once a
year. Remove the drain plug (7) and remove the oil level
and filler plug (6) and allow all of the oil to drain out. Re¬
place the drain plug. Refill with approved lubricant up to
the level plug opening and replace the plug.
Check the oil level periodically. Keep the lubricant up to
the level plug (8) on the left side of the creeper drive
housing. Drain and refill the housing each time the oil is
changed in the transmission case. To change the oil| re¬
move the drain plug (10) at the bottom of the housing and
allow all the oil to drain. Then replace the drain plug.
Remove the breather and oil filler plug (9) at the right of
the creeper shift handle on top of the frame assembly^ and
remove the oil level plug (8). Fill to the level plug opening
with approved lubricant and replace the plugs.
11 • Steering geor housing.
Miscellaneous
Once a year» apply two strokes of the lubricatori using
IH 25IH EP grease or equivalent #2 multi-purpose lithium
grease.
Note: To locate the lubrication fitting» turn the front
wheels to the maximum right turn position. Then reach up
under the right side of the tractor frame to locate the
fitting.
Lubricate the clutch pedal shaft and linkage with eight or
ten drops of engine oil.
32