Electric Lift - International Harvester Company INTERNATIONAL Cub Cadet 73 Operator's Manual

ELECTRIC LIFT
MA-tSO^A
1. End clevis locking clip
2. SoMy guard
Illust. 17
Electric lift ossembled on tractor.
The electric lift is a self-contained unit
designed to provide power with fingertip con¬
trol for raising and lowering center mounted
equipment.
OPERATING INSTRUCTIONS
The electric lift is operated by a control
switch located on the upper righthand corner
of the instrument panel. To raise the imple¬
ment push upward on the control switch until
the desired height is reached, then release the
ENGINE COOLING
ENGINE COOLING
This tractor has an air cooled engine. Air
must be able to circulate freely around the en¬
gine, through the screen and shroud, and over
the fins of the cylinder head and cylinder block.
Keep these areas free of accumulated dirt and
trash or the engine will overheat and result
in damaged moving parts. Periodic cleaning
with compressed air will keep this area clear
for adequate cooling.
DRY TYPE AIR CLEANER
Incoming air for combustion is filtered by
a dry-type air cleaner having a filter element
inside of the cover.
Remove and clean or replace the element
with a new one when loss of power is notice*
able. Replace at least once a year.
switch. The switch will return to the center
or neutral position. The equipment will "bold*'
in whatever position desired when you release
the control switch. To lower the equipment
push down on the control switch. The switch
will again return to the center or neutral posi¬
tion when you release it.
Note; Always operate the electric lift with
the tractor engine running. Operation of the
electric lift off of the battery only will cause
premature battery failure.
Caution! Whenever raising or lowering equip¬
ment release the control switch when the
equipment has reached a fully raised or
lowered position. Not doing so can result in
damage to the electric circuits.
Note: Never operate the electric lift with
the safety guard removed.
To operate equipment in 'Vigid** position,
the end clevis locking clip must be in the
locked position as shown in Mlusf. 17.
To operate equipment such as a mower in
**floot*' position, raise the end clevis locking
clip to the unlocked position. See lllusL 17.
AND AIR CLEANER
lllust. 17A
Removing the air cleaner filter element.