Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Miele DA 5690 W
Summary of Contents for Miele DA 5690 W
- Page 1 Operating and installation instructions Cooker hood DA 5690 W, DA 5690 W EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
-
Page 2: Table Of Contents
Miele|home ........ -
Page 3: Caring For The Environment
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled. -
Page 4: Warning And Safety Instructions
Any other usage is not supported by requirements. Inappropriate use the manufacturer and could be can, however, lead to personal injury dangerous. Miele cannot be held liable and damage to property. for damage resulting from incorrect or improper use or operation. - Page 5 Faulty components must only be the appliance could be damaged. replaced by genuine Miele original Consult a qualified electrician if in any parts. The manufacturer can only doubt. guarantee the safety of the appliance...
- Page 6 These models may only be combined with a Miele external motor. This appliance must not be used in a non-stationary location (e.g. on a Great care should be taken when ship).
- Page 7 Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heating appliance are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
- Page 8 Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
- Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
-
Page 10: Guide To The Appliance
Guide to the appliance... - Page 11 Guide to the appliance a Telescopic extension piece m Sensor for the grease filters b Tower The sensor lights up when the grease filters need to be cleaned. c Canopy It is used to reset the operating hours d Sensor controls counter every time the grease filters are The symbols act as sensors.
-
Page 12: Modes Of Operation
Modes of operation . . . air recirculation: The cooker hood works with (this requires an optional conversion kit and charcoal filter: see "Technical Data") . . . air extraction: The air is drawn in and cleaned first by The air is drawn in and cleaned by the the grease filters and then by a grease filters and directed outside. -
Page 13: Miele|Home
Miele electric of the cooker hood. hob with onset controls. This module must be installed by a... -
Page 14: Operation
Operation To switch the fan on s Automatic switch-off of the Intensive setting ^ Touch the s sensor. You can set the Intensive setting so that The fan will come on at power level 2. it always only runs for 10 minutes The s and 2 sensors will light up. -
Page 15: Run-On Option "5M15
Operation Run-on option "5m15" To dim the hob lighting It is advisable to leave the fan running The brightness of the hob lighting can for a few minutes after cooking has be adjusted. finished to neutralise any lingering ^ With the lighting switched on, touch odours in the air. -
Page 16: Operating Hours Counter L
Operation Operating hours counter l| Altering the grease filter operating hours counter The number of hours the appliance has been in operation is stored in memory. You can set the operating hours counter to suit the type of cooking you The operating hours counters tell you when the grease filters or charcoal filter need to be cleaned or replaced. - Page 17 Operation ^ Confirm your selection by touching If you do not confirm within 4 minutes, the l sensor. the cooker hood will automatically revert to the original setting. All the lamps will go out. The charcoal filter touch sensor | will If you do not confirm within 4 minutes, light up after the cooker hood has the cooker hood will automatically...
-
Page 18: Sensor Tones
Operation Sensor tones When selecting a function with the sensors, an audible tone will sound briefly to confirm. The audible tone can be deactivated. ^ Touch the s sensor to switch the fan off. ^ Touch the 4 sensor and the grease filter sensor l at the same time for approx. -
Page 19: Cleaning And Care
Cleaning and care A range of Miele branded cleaning and Do not use: conditioning products is available to – cleaning agents containing soda, order from Miele (see back page for acids, chlorides or solvents, details) or the via the internet at www.miele-shop.com. -
Page 20: Grease Filters
Cleaning and care Grease filters Important for appliances with glass surfaces The re-usable metal grease filters in the ^ Glass surfaces can be cleaned using appliance remove solid particles a proprietary non-abrasive cleaning (grease, dust, etc.) from the kitchen agent designed specifically for use vapours, preventing soiling of the on glass. -
Page 21: Resetting The Grease Filter Operating Hours Counter
^ Do not wash at more than 65° C. If a ^ Whilst the fan is switched on, press Miele dishwasher is being used, the Operating hours control l— for select the Sensor wash programme. -
Page 22: Fitting And Replacing The Charcoal Filter
6 months. Used charcoal filters can be disposed New charcoal filters can be of with the normal household waste. purchased from your Miele dealer, from the Miele Spare Parts Resetting the Charcoal filter Department or via the internet at operating hours counter www.miele.shop.com. -
Page 23: Changing A Halogen Lamp
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Exercise caution when changing halogen lamps. They get very hot during use and remain hot for some time after being switched off. Let them cool down before you change them. -
Page 24: After Sales Service
For information on the appliance under guarantee, please contact: guarantee specific to your country – Your Miele Dealer / Chartered Agent please contact Miele. See back cover for contact details. In the U.K. your appliance is –... -
Page 25: Appliance Dimensions
650 mm above an open grill or deep fat fryer, 650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance 1) Extraction of 760 mm must be maintained... -
Page 26: Installation
Installation Assembly parts dai2715... - Page 27 Installation a 3 protective sheets for use when fitting the tower. b 1 exhaust connection for exhaust 2 x M 6 self-tapping nuts ducting C 150 mm. for securing the appliance. c 1 reducing collar for C 125 mm exhaust ducting. d 1 non-return valve for fitting into the exhaust connection 2 screws 3.9 x 7.5 mm...
-
Page 28: Installation Instructions
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet. -
Page 29: Connection For Air Extraction
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as... -
Page 30: Condensate Trap
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue. -
Page 31: Silencer
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit a. -
Page 32: Electrical Connection
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual... -
Page 33: Operation With Control Module Dsm 400
Operation with Control module DSM 400 The Miele DSM 400 control module can Components used in the central be used to combine the cooker hood ducting system are not supplied by with other components. Miele. It enables the following: If in any doubt, the advice of a... -
Page 34: Technical Data
Weight DA 5690 W ....28 kg Level 1....180 m DA 5690 W EXT . - Page 36 Alteration rights reserved / 3011 M.-Nr. 09 204 070 / 00...