Hard Disk Drive Pack; Removing The Hard Disk Drive Pack - Toshiba Tecra M9 User Manual

M9

Hard disk drive pack

An extra hard disk drive expands the flexibility of your system and allows
you to carry your data separately without having to carry the computer.
Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.

Removing the hard disk drive pack

To remove the hard disk drive pack, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the
Chapter 1,
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
Modes, if required).
4. Loosen two screws securing the hard disk drive cover in place.
5. Lift the cover up and out, and remove it from the computer.
6. Pull the hard disk drive pack up to a vertical position by holding the
plastic tab.
3-26
Getting Started, if required).
section in Chapter 6,
Hard disk drive cover
Removing the hard disk drive cover
Turning off the power
Power and Power-Up
section in
Screws
User's Manual