How To Set E.s.p - LG LB-C246HSA0 Instruction Manual

How to Set E.S.P?

Procedure of RPM change:
Ex) External Static pressure is 4mmAq for Model Name "LB-C246HSA1"
• To protect the unit, compressor is designed to be off during E.S.P. setting.
Push the "On/Off" button.
1
The unit will start.
2 Push the "Timer" and "Wind" button simultaneously for more then 3 seconds.
Timer
3 Push the "Up" of "Down" button for E.S.P adjustment.
And, adjust the number which you want.(In this example, the number is "190". Refer
to the table 1 on the next page.)
The range of selection is from 1~254. Since, the display is two Digit only.
NOTICE
If the range selection is above 100 then the third digit will appear in the screen as shown.
4
Shift the fan speed mode by pressing the fan speed button.
And then, Adjust numbers of next steps by repeating the stage 3.
(In this example, the numbers are "220" and "235" respectly)
5
Push the "Timer" and "Wind" button simultaneously for more than 3 seconds.
Then, Wind Data is memorized by the EEPROM of the main PCB.
Timer
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI
MED
LO
Time
Timer Operation unit Program set
On Off
01 03 05 07 09 11 13 15
Set no. Time
AUTO SWING OPERATION SET TEMP FAN SPEED
Room Temp
Time
Operation unit Program set
Timer
On Off
Set no. Time 01 03 05 07 09 11 13
AUTO SWING OPERATION SET TEMP FAN SPEED
Room Temp
Time
Timer Operation unit Program set
On Off
01 03 05 07 09 11 13
Set no. Time
AUTO SWING OPERATION SET TEMP FAN SPEED SUB FUNCTION
Room Temp
HI
MED
LO
Time
Timer Operation unit Program set
On Off
Set no. Time 01 03 05 07 09 11 13 15
How to Set E.S.P?
AUTO Heater Preheat
JET Defrost Humidify
Filter Out door
ZONE 1 2 3 4
17 19 21 23
SUB FUNCTION
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
1 2 3 4
ZONE
15 17 19 21 23
SUB FUNCTION
HI AUTO Heater Preheat
MED JET Defrost Humidify
LO Filter Out door
ZONE 1 2 3 4
15 17 19 21 23
AUTO Heater Preheat
JET Defrost Humidify
Filter Out door
1 2 3 4
ZONE
17 19 21 23
Installation Manual 27