Russound BTC-2 Manual page 8

USING WITH A MCA-SERIES CONTROLLER
Audio output from the BTC-2 can be either analog stereo RCA or optical digital. You are free to use either one depend-
ing on your preference or the availability of inputs on your amplifier or receiver.
From the BTC-2, simply connect either the RCA analog stereo outputs to your amplifier or receiver or connect the Tos-
link Digital Optical connection depending on your available inputs on your amplifier or receiver (cables not included).
USING YOUR BTC-2X WITH A RUSSOUND MCA-SERIES CONTROLLER
The BSK-2 Bluetooth Source Kit can be used when adding more than one Bluetooth source to a Russound MCA-Series
Controller. All of the connections are made as listed above, but several additional steps are necessary:
Setting the Source Number
Before using the BTC-2X with a Russound MCA-66 or MCA-88, the source number switch on the bottom of the BTC-
2X must be properly set to the same source number that is configured in the MCA-Series controller's WebConfig.
Set the rotary dial on the bottom of the BTC-2X to correspond with the same source number to be used on the MCA-
66 or MCA-88 controller. Make sure that the MCA-Series controller's associated source type is configured with the
Source Type of "BTC-2X".
Connecting to the Controller
Use a CAT-5 cable to connect one of the RNET ports on the back of the BTC-2 to an open RNET port on the rear of the
MCA-Series controller.
When adding more than one BSK-2 kits, continue connecting from an open RNET port on the additional BTC-2 to an
open RNET port on the controller or on a previously connected BTC-2. In other words, the BTC-2 boxes must be daisy
chained together and then to the controller.
Russound BTC-2X Installation Guide 7