Table of Contents
Advertisement
14
www.aeg.com
8.3 Introduction
The options/functions are
not selectable with all
washing programmes.
Check the compatibility
between options/functions
and washing programmes in
the "Programme Chart". An
option/function can exclude
another one, in this case the
appliance doesn't allow you
to set the incompatible
options/functions together.
Make sure the screen and
touch buttons are always
clean and dry.
8.4 Temperatuur
When you select a washing programme,
the appliance automatically proposes a
default temperature.
Set this option to change the default
temperature.
The indicator
temperature comes on (the appliance
does not heat the water).
8.5 Centrifugeren
When you set a programme, the
appliance automatically sets the
maximum spin speed allowed.
Touch repeatedly this button to:
Decrease the spin speed
Activate the Spoelstop option
• Set this option to prevent the laundry
creases.
• The related indicator comes on.
• There is a water in the drum when the
programme is completed.
• The door stays locked and the drum
turns regularly to reduce creasing.
• You must drain the water to unlock
the door.
• If you touch the Start/Pauze button,
the appliance performs the spinning
phase and drains the water.
The appliance empties the
water out automatically after
18 hours approximately.
= cold water of the set
Activate the No spin option
• Set this option to deactivate all spin
phases. Only the drain phase is
available.
• The related indicator comes on.
• Set this option for very delicate
fabrics.
• The rinses phase uses more water for
some washing programmes.
The spin speed can be
reduce.
8.6 Extra
Press this button repeatedly to activate
one of the available options.
• Vlekken
Select this option to add an anti-stain
phase to a programme in order to
treat heavily soiled or stained laundry
with stain remover.
Pour the stain remover into
compartment . The stain remover will
be added in the appropriate phase of
the washing programme.
This option can increase
the programme duration.
This option is not
available with a
temperature lower than
40 °C.
• Voorwas
Use this option to add a prewash
phase at 30 °C before the washing
phase.
This option is recommended for
heavily soiled laundry, especially if
containing sand, dust, mud and other
solid particles.
This option can increase
the programme duration.
The relevant indicator comes on.
8.7 Startuitstel
With this option you can delay the start of
a programme in a more convenient time.
Touch repeatedly the button to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
Advertisement
Table of Contents
