Monitor; Crt Assy - GE LOGIQ 5 Service Manual

GE M S
EDICAL YSTEMS
D 2300000, R
IRECTION EVISION
Section 8-3

Monitor

8-3-1

CRT Assy

Purpose: This is a description on how to remove and replace the CRT Assy.
8-3-1-1 Tools
• Common pillips screwdrivers
• Allen/Unbraco wrench
8-3-1-2 Needed Manpower
• 2 persons, 5 minutes + travel
8-3-1-3 Preparations
• Shut Down the System and switch off the Main Breaker at the rear as described in section 4-3-2 on
page 3.
• Maneuver Control Console to a suitable position for removing the monitor.
8-3-1-4 Removal procedure
1.) Remove the OP Rear Cover. Refer to section 8-5-10 on page 56.
2.) Unscrew one screw cap located at (1).
8-2
2
Figure 8-1 Removing OP rear Cover and Unscrew screw
Section 8-3 - Monitor
(1)
LOGIQ™5 S M
ERVICE ANUAL