Haier HLT364XXQ User Manual page 15

Select a suitable location for the washer on a hard even surface away from
direct sunlight or heat source e.g. radiators, baseboard heaters, cooking
appliances etc. Any floor unevenness should be corrected with the leveling
legs located on the bottom corners of the washer. The washer must be placed
at room temperature. You must not place washer where the temperature is at
below freezing.
®nstamJing
Your Washer
Read installation instructions carefully before installation.
Cc_ution:
If, after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your washer is
properly installed it is recommended that it be installed by a certified
instalJen
1. Insert a new flat washer into each end of the water inlet hoses. Firmly put the
washer in the coupling.
Note: You may have to use pliers to tighten the coupling.
Do not over tighten because you may cause damage to the valve.
2. Connect the hot and cold water inlet hoses to the hot and cold water faucet.
14