FRAME/BODY PANELS/EXHAUST SYSTEM
FRONT INNER COVER
REMOVAL/INSTALLATION
Remove the following:
– Front center cover (page 3-4)
– Floor panel (page 3-11)
Remove the following:
– Two screws from the inner cover front side
– Two screws from the inner cover rear side
Release the following:
– ECM grommet from the front inner cover stay
– Turn signal relay grommet and starter relay
grommet from the front inner cover stay
Open the inner box, then remove the bolt and lug-
gage hook.
Release the two bosses from the holes and remove
the front inner cover.
Installation is in the reverse order of removal.
REAR FENDER
REMOVAL/INSTALLATION
Remove the body cover (page 3-9).
Release the following:
– Radiator reserve tank overflow hose
– Siphon hose
Disconnect the license light 3P connector.
Remove the rear fender by slightly pulling it back-
ward and releasing the tab and bosses.
Installation is in the reverse order of removal.
3-12
FRONT INNER
TURN SIGNAL
COVER
RELAY GROMMET
STARTER RELAY
GROMMET
ECM
GROMMET
SCREWS
SIPHON HOSE
TAB
BOSSES
REAR
FENDER
LUGGAGE
HOOK
BOLT
INNER BOX
BOSSES
OVERFLOW
HOSE
3P CONNECTOR