Advertisement
Cleaning the Beard Trimmer Attachment
Clean the beard trimmer attachment with the cleaning brush provided, brush away
hair clippings from the blades, and top of trimmer handle.
NOTE: If you rinse these attachments with cool or warm water (never use hot
water) or use it in the shower then the blades will need to be lubricated with light-
grade oil or sewing machine oil (1-2 drops over the cutters) every month.
Weekly:
1.
Perform the daily cleaning steps 1 and 2.
2.
Remove the hair pocket from the head & cutter assembly. (Diagram L) Place
the body of the shaver aside.
3.
Slide the blue cutter support frame upwards towards the direction of the two
cutters to release it from the assembly. (Diagram M)
4.
Lift and remove the cutter support frame away from the cutters.
5.
Remove the cutters. (Diagram N)
6.
Thoroughly rinse away any debris from inner and outer cutters with warm
water.
7.
Replace the inner cutters. (Diagram O) The inner and outer cutters are colour
coded (orange, blue and black) to ensure each cutter is returned to its original
and most effective position on the cutter assembly.
8.
Hold the cutter support frame with the raised center section facing upwards.
Place it over the cutters so that the centre mouth opening is facing the blue
cutter. Slide the cutter carrier towards the blue cutter until the locking tab
locks under the centre triangle. (Diagram P)
9.
Lubricate each cutter with Remington Shaver Saver (SP4).
10. Gently reattach the hair pocket to the neck assembly until it lock in place
on all three sides. The hair pocket may be reattached in any configuration.
(Diagram Q)
** Pop Up Trimmer: Lubricate teeth with oil every six months
L
P
M
N
Q
9
O
Advertisement
