Table of Contents
Advertisement
2
ASSEMBLY
Section
WARNING
If any bolts or nuts are dropped in the machine, be sure
to remove them before starting the machine.
NOTE
Axle, wheel and hitch assemblies for some models
are supplied by the distributor and may vary from the
illustrations shown in this manual.
2.1 ATTACH TRAILER WHEELS
1. Hold one wheel to a hub and align the wheel lug holes
with the hub lug studs.
2. Thread the lug nuts on the hub studs and tighten to 75
ft-lbs. Follow a star pattern when tightening lug nuts.
3. Repeat for the remaining wheel.
4
5
3
Figure 2.1, Trailer Hitch Assembly (CE Compliant Shown)
6
1
6
2
8
2
7
5 INCH CHIPPER
2.2 ATTACH TRAILER HITCH
1. First, attach the hitch pole assembly (8) to the hitch
channel in the trailer deck bottom with three 3/8 x 3"
bolts (1) and nylock nuts (2). (See Figure 2.1.)
NOTE
Three coated clamps (6) will be used for wiring harness
mounting and routing (Figures 2.1 and 2.3) purposes.
Place wiring harness in clamps before securing the
clamps in place on the bolts. See Figures 2.1 and 2.3
for clamp locations.
2. Next, place the two hitch plates (3) over the axle and
attach to hitch pole using two 1/2 x 3-1/4" bolts (4),
washers (5) (CE compliant model only) and nylock
nuts (7) as shown in Figures 2.1 and 2.2.
Figure 2.2, Hitch Pole Assembly Bolt Locations
6
6
Figure 2.3, Wire Harness Routing (CE Compliant Shown)
6
Advertisement
Table of Contents
