Assembly; Installing The Handle; Installing The Hopper; Installing The Chipper Chute Extension - Echo BEARCAT sc3206 Owner's Manual

2

assEmbLY

Section
WaRNING
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
Remove items from the shredder area by removing
the discharge screen.

2.1 INsTaLLING THE HaNdLE

1. Remove the chipper/shredder and hopper assembly
from the shipping box and pallet.
2. Install four 5/16" X 3/4" bolts so the head of the bolt is
located on the inside of the hopper. Fasten bolts with
5/16" nylock nuts and 5/16" flat washers.

2.2 INsTaLLING THE HoppER

1. Assemble the hopper assembly to the frame so the
handle is located above the engine and the opening
is toward the chipper chute.
2. Install twelve 5/16" X 3/4" bolts so the head of the
bolt is inside the hopper. Fasten bolts with 5/16" flat
washers and 5/16" nylock nuts.
CHIPPER
EXTENSION
(WHERE AVAILABLE)
6
HOPPER
3 INCH CHIPPER/SHREDDER
2.3 INsTaLLING THE cHIppER cHuTE
ExTENsIoN
NOT AVAIlABlE ON All MODElS
1. Place the chipper chute extension onto the chute.
line up the four holes located on the bottom of the
extension and the top of the chute.
2. Install four 5/16" X 3/4" bolts so the head of the bolt
is located on the inside of the chipper chute. Fasten
bolts with 5/16" nuts. Tighten nut until snug against
the chute extension.

2.4 INsTaLLING dIscHaRGE assEmbLY

NOT AVAIlABlE ON All MODElS
1. Place the discharge weldment onto the chipper. The holes
on the weldment should line up with holes on the chipper.
2. Secure the top of the discharge weldment using one
5/16" x 7-1/2" bolt (narrow door) or one 5/16" x 10" bolt
(wide door) and 5/16" nuts. Tighten to proper torgue
3. Secure the bottom of the discharge weldment using
two 5/16" x 3/4" bolts and 5/16" nuts. The head of the
bolt should be located inside the discharge assembly.
Tighten to the proper torque.
HANDLE
DISCHARGE
ASSEMBLY
(WHERE AVAILABLE)