Table of Contents
Advertisement
• When a laundry overload is detected
during ProSense phase (a double
sound played one).
To activate/deactivate this option, hold
down the Extra Rinse button until a beep
or a double beep sounds.
If you deactivate this
function, the acoustic signals
stops playing at the end of
the programme only.
8.3 Child Lock
With this option you can prevent children
from playing with the control panel.
To activate/deactivate this option, hold
down the Stains/Prewash button until
comes on/goes off on the display.
The appliance will default to this option
after you switch it off.
8.4 Operating Hours Counter
It is possible to visualise the total
operating time of the appliance in hours,
starting from the first switching on. This
value will count operating time of the
cycles (does not include pauses, delayed
start time). To visualise this value,
proceed as follows:
1. Switch the appliance on by pressing
the On/Off button.
9. BEFORE FIRST USE
During installation or before
first use you may observe
some water in the appliance.
This is a residual water left
in the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1. Make sure that all transit bolts have
been removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.
2. Press and hold the Extra Rinse and
Plus Steam buttons for some
seconds.
3. After 3 seconds the total hours
operated by the appliance are shown
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
4. To exit this mode, press any button
or switch the appliance off by means
of theOn/Off button.
If the procedure does not
work (due to timeout or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
8.5 Factory Defaults
This function allows to restore the factory
default options. To activate this option
follow steps below:
1. Switch the appliance on by pressing
On/Off button.
2. Press and hold the Stains/Prewash
and Time Save buttons for some
seconds.
3. The display will show
about 5 seconds.
3. Make sure to fill the AutoDose tanks
with liquid detergent
softener
. Refer to "AutoDose
basic setting " paragraph in "The
AutoDose technology" chapter.
4. Pour 2 litres of water inside the drum.
This action activates the drain system.
5. Set and start a programme for cotton
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
ENGLISH
21
for
and fabric
Advertisement
Table of Contents
