Emptying The Dust Cup - Electrolux Z5740 Series Owner's Manual

The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust
cup, filters, belt, and brush roll often. We suggest emptying the dust cup after every use.
NOTE: When vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances,
the dust cup and filters will require more frequent maintenance.
NOTE: Turn off the switch and unplug the electrical cord before changing the filter. Never operate the
vacuum cleaner without the dust cup or filter assembly in place.
Emptying the Dust Cup:
@) Remove dust cup by pulling latch upward and Q@) Grasp dust cup lid and twist anticlockwise
pivoting dust cup out and away from cleaner. to remove.
6) Lift filter up and out of dust cup with a twisting @ Dump debris in a waste container.
motion.
Reinstalling the Dust Cup:
@) Replace filter onto centre tube in dust cup applying gentle pressure.
@) Line up tabs on dust cup with openings on lid, rotate Tab
lid clockwise while applying pressure to secure. The
lock symbol () on lid will be centered over dust cup Tab
handle when properly assembled. a
@) To replace dust cup, position dust cup with handle facing inside the dust cup
compartment; place bottom of dust cup in bottom of compartment and rotate
upward, pushing dust cup against cleaner until it locks into place.
@ Dust cup will not properly seat if the filter is not present.
10