Advertisement
3. The debris filter is dirty
(1) Remove the debris filter, located under the Dirty Water Tank, wipe it clean.
4. There is a clog in the tool at the end of the hose.
(1) Remove the tool and clear out any debris.
5. The Unit needs to be reset
(1) To reset the PowerDash, unplug it from the wall. Remove the nozzle cover and take out
the brushes. Now, replace the nozzle cover, plug the unit back in, and cycle the power on
and off 4 times. Replace the brushes and test to see if the reset worked.
E. Brushroll Not Spinning
1.
Make sure the unit is NOT in the upright position
(1) If the unit is in the upright position, the brushroll won't spin. Tilt the unit backwards.
2. The brushroll stall protection has been activated. This happens when the brushroll gets
jammed or clogged.
(1) Turn the unit off and back ON again.
(2) Make sure to remove your brushroll and clean any tangled hair or debris that could be
causing the stall. Temember to clean the notches inside the nozzle too.
See below
Advertisement
