Advertisement
Troubleshooting
A. Unit Leaking
1. The clean and dirty tank are not placed properly or might be filled.
(1) Check to ensure all tanks are properly filled or empty (dirty water tank cannot be over the
max limit, to prevent leaking through the motor)
(2) Ensure the tanks are firmly placed into the unit and there are no gaps or looseness.
2. Dirty Water Tank Lid is not secure.
(1) Make sure there are no gaps in your dirty water tank. Also check that the lid of your tank
is properly fitted in.
3. Check tanks to determine if leaking occurs while installed or removed from unit.
Clean Tank does have an amount of residual water when removed from tank resoivour.
Check tank caps to ensure seals are in place and sealing tanks.
4. Remind the customer to allow residual water to make its way back into the dirty water tank
after they are done cleaning. This is to prevent leaking once its stored.
B. Unit Won't Dispense
1. Clean Water Tank is Empty and the handle is loose
(1) Check to ensure that the Clean Water Tank and solution tank is properly filled and
properly fitted into the unit
(2) The unit will not dispense if the handle is not properly installed
2. Unit may need to be flushed.
(1) Add warm tap water to both the clean water tank and the solution tank. Make sure both
Advertisement
