How To Use - Tiger PCG-G10S Instruction Manual

Names of parts
‘ Check each part first after unpacking the product.
Dispense lock
This product consists of
button
two separate parts: the
main unit and the power
plate.
Lid gasket
Inner container
Main
unit
Spout
Power plate Main
unit
Power plate
Water level scale
[PCG-G10S]
Provided on the inner container.
Full water
level (1.0 L)
[PCG-G10V]
How to adjust the length of the power cord
Wrap the power cord around the bottom of the power plate to
adjust the length and lead it out from the power plate cutout.
Lead the
power cord Power plate
cutout
out from the
cutout.
Power cord
When using the appliance for the first time or after a long time without use
In order to clean the inside of the main unit, take the following steps to boil water and discharge it.
* Although resin or other materials may smell for the first several uses, they become less noticeable with use.
1. Pour water up to the full water level and boil it.  P. 9, P. 10
2. After it boils, drain it from the spout.  P. 10
3. Remove the lid to drain any remaining hot water.  P. 10
8
Open/close levers
Boil lamp
Lid
Power
switch
Steam
gasket
Main unit
connector
Power plate
Bottom Handle
connector
Power cord
Plug
Power plate
cutout
Wrap
Power cord

How to use

Pinch the open/close
Remove the main unit from the power plate and
levers with your fingers 1
to remove the lid.
remove the lid.
(2)
(1)
Lid
Open/
(1)
close
levers
Pour water slowly.
2
Pour water in the main unit and attach the lid.
Do not splash
water over the
power switch.
‘ Use another container to pour in water.
‘ Do not fill water above the full water level.
Push the lid firmly until the left and
right tabs are set in their positions
one after another.
Lid
Spout
on lid
Tab
Spout
Clicks
on the
main
unit
Concave
y Do not fill water directly from a faucet or place the main unit on a
y
wet surface to avoid the bottom getting wet.
y Do not fill water for boiling above the full water level.
y
y Do not fill water in the main unit while it is placed on the power plate.
y
Doing so may cause a malfunction.
3
OFF
Mount the main unit properly on the power
plate.
‘ Put the power plate on a flat surface.
‘ Wrap the power cord around the
bottom of the power plate to adjust
the length and lead it out from the
power plate cutout.
‘ Check that the power switch is OFF before mounting the main unit.
Main unit
Mount
connector
straight
Power plate connector y Do not boil water unless the main unit is mounted straight on the
y
power plate. (Mount the main unit straight, without tilting or being
raised.)
Clicks
Caution
P. 8

Caution
9