Troubleshooting - Biostar B250GT6 Manual

4.4 Troubleshooting

Probable
1. There is no power in the system. Power LED does
not shine; the fan of the power supply does not work
2. Indicator light on keyboard does not shine.
System is inoperative. Keyboard lights are on, power
indicator lights are lit, and hard drives are running.
System does not boot from a hard disk drive, but can
be booted from optical drive.
System only boots from an optical drive. Hard disks
can be read, applications can be used, but system
fails to boot from a hard disk.
Screen message shows "Invalid Configuration" or
"CMOS Failure."
System cannot boot after user installs a second hard
drive.
CPU Overheated
If the system shutdown automatically after power on system for seconds, that means the CPU
protection function has been activated.
When the CPU is over heated, the motherboard will shutdown automatically to avoid a
damage of the CPU, and the system may not power on again.
In this case, please double check:
1. The CPU cooler surface is placed evenly with the CPU surface.
2. CPU fan is rotated normally.
3. CPU fan speed is fulfilling with the CPU speed.
After confirmed, please follow steps below to relief the CPU protection function.
1. Remove the power cord from power supply for seconds.
2. Wait for seconds.
3. Plug in the power cord and boot up the system.
Or you can:
1. Clear the CMOS data. (See "Close CMOS Header: JCMOS1" section)
2. Wait for seconds.
3. Power on the system again.
34 | Chapter 4: Useful help
Solution
1. Make sure power cable is securely plugged in.
2. Replace cable.
3. Contact technical support.
Using even pressure on both ends of the DIMM,
press down firmly until the module snaps into place.
1. Check cable running from disk to disk controller
board. Make sure both ends are securely plugged in;
check the drive type in the standard CMOS setup.
2. Backing up the hard drive is extremely important.
All hard disks are capable of breaking down at any
time.
1. Back up data and applications files.
2. Reformat the hard drive. Re-install applications
and data using backup disks.
Review system's equipment. Make sure correct
information is in setup.
1. Set master/slave jumpers correctly.
2. Run SETUP program and select correct drive types.
Call the drive manufacturers for compatibility with
other drives.