Sony Trinitron KV-20TS27 Operating Instructions Manual page 24

Specifications
American TV standards
VHF: 2-13
UHF: 14 - 69
Cable TV: 1-125
Microblack™ Trinitron tube
20-inch picture measured
diagonally
21-inch picture tube measured
diagonally
75-ohm external antenna terminal
for VHF/UHF
VIDEO INPUT (phono jacks)
Video: 1Vp-p, 75-ohms
unbalanced, sync negative
Audio: 500 mVrms
(100% modulation)
impedance: 10 kilohms
AUDIO OUTPUT (VARIABLE)
(phono jacks)
More than 408 mVrms at the
maximum volume setting
(variable) (100% modulation)
120 V AC, 60Hz
110 — 240 V AC, 50 Hz, auto volt
system (KV-21STR1 only)
125 W (Max.)
5 W (in standby condition)
KV-21STR1: 110 W (Max.)
3 W (in standby condition)
527.0 x 488.5 x 482.0 mm (W/H/D)
(20 %" x 19 %" x 19")
KV-20TS27, KV-20TS28,
KV-2137RS: 23.4 Kg (51 Ibs 10 oz)
KV-21STR1: 24.5 Kg (54 Ibs 20 oz)
KV-20TR22, KV-2127R:
23.1 Kg (50 Ibs 15 02)
Television system
Channel coverage
Picture tube
Antenna
Input
Output
(KV-20TS27,
KV-20TS28 and
KV-2137RS only)
Power requirements
Power consumption
Dimensions
Weight
Supplied accessories
et | oe
RM 783 (1)
[ kv-2oTsze | RM-783(1) | KV-2127R_|_AM-781 (1)
RM-781(1) | KV-21STR1| RM-783(1)
All Models VHF/UHF telescopic dipole antenna (1)
(except Canada)| Antenna connector (1)
KV-21STR1 only: Power cord plug adaptor+
UN mixer EAC-66
Connecting cable
VMC-606/607M
VMC-810S/820S
RK-74A
* AC power cord connection
If the power cord plug cannot be inserted into the wall outlet, use
the supplied power cord plug adaptor.
Design and specifications are subject to change without
notice.
Sonv Corporation Printed in U.S.A.
ae
ag
2
®
Optional accessories
>
aTxert tstourevevtiate
Disturbances in picture and sound can often be eliminated by
checking the symptoms and following the suggestions listed
below.
a SYMPTOM CHECK AND ADJUST
+ Adjust PICTURE.
«¢ Adjust BRIGHT.
« Check antenna/cable
connections.
¢ Press VOLUME +.
¢ Release MUTING on the
Remote Commander.
¢ Check that the MTS
button is set correctly.
¢ Check that the TV/
VIDEO button is set
correctly.
¢ Set the SPEAKER switch
to ON.
«ls POWER switched on?
« Power in outlet?
¢ Check that the TV/
VIDEO button is set
correctly.
«Is it a color program?
¢ Adjust COLOR.
* Is it an active or the
correct channel?
¢ Check the CABLE
selector setting.
¢ Check antenna/cable
connections.
Poor or no picture
(screen not lit),
good sound
Good picture,
no sound
No picture (screen
not lit), no sound
Snow and noise
This is often caused by
local interference. (e.g.
cars, neon signs,
hairdryers etc.) Adjust
antenna for minimum
interference.
Reflections from nearby
mountains or buildings
often cause this problem.
A highly directional
outdoor antenna or a
CATV cable may improve
the picture.
Try another channel. It could be station trouble.
If so, the settings have
been erased.
If the problem persists, contact your nearest service facility.