Sony Trinitron KV-20TS27 Operating Instructions Manual page 19

Setting the Program Start TIMER
Make sure that the clock has been set correctly before setting the program start TIMER. (p. 17)
EXAMPLE: To set the TIMER for a program which begins at 10:30 PM on channel! 12
From "NORMAL page," (no display) press
TIMER/BLOCK once to change to "clock page."
TIMER/BLOCK
=
8:05em
"clock page"
Press 1, 0, 3, 0, AM/PM, ENTER. The screen
display will blink once, indicating that the time has
been set.
mom
oon
moo
OISPLAY ENTER
LJ
The TIMER lamp will light up, indicating that the TIMER has
been set.
If you make a mistake, press CLEAR and proceed from step 3.
At the preset time, the selected channel will appear on the screen
and the TIMER lamp will go out. The TIMER will operate whether
you are watching a TV program or a VCR playback, or even if the
TV is turned off.
if no button is pressed within 2 hours after the preset time, an
"OFF" display will appear on the screen for 1 minute. If a button is
Still not touched during that minute, the TV will turn off automatically
as a safety precaution.
Press TIMER/BLOCK again before the "AM"/*PM"
indication disappears to summon "TIMER page."
TIMER/BLOCK
"TIMER page" (green display)
Press 1, 2, ENTER (0 not necessary). The screen
display will blink once, indicating that the channel has
been set.
omc
eye
mom
Sos
( ER SET )
10: 30em CH 12
The TIMER operates only once, but the time and the channel will
remain in the TV's memory.
To preset the same channel! at the same time for a future date,
press OFF/REPEAT. The TIMER lamp will light up, indicating that
the TIMER has been reactivated.
To deactivate the TIMER, press OFF/REPEAT again so that the
TIMER lamp goes out. It is not necessary to summon "TIMER
page" before using the OFF/REPEAT button. Furthermore, this
button is effective even if the TV is turned off.
To clear the TIMER setting, summon "TIMER page" and press
CLEAR.
To reset, clear the setting and follow the steps from step 3.