Zanussi FJ 1224/A Instruction Booklet page 28

e CAUSE
> SOLUTION
B THE MACHINE LEAKS OR
OVERFLOWS
B THE MACHINE VIBRATES
OR IS NOISY
BN THE DOOR DOES NOT OPEN
Too much washing powder
@ Unsuitable washing powder
The inlet hose ring is loose
The detergent dispenser
drawer or recess are clogged
The end of the drain hose is
not securely positioned
The internal packing has not
been removed
The machine is not level
The machine is in contact
with the wall or furniture
Washing load badly
distributed
The machine is overloaded
The safety device has locked
it (door pilot light on)
Water in the wash tub
> Reduce the quantities of
washing powder
Only use washing powder
suitable for automatic machines
Tighten the ring (see page 8)
Clean the drawer and recess
(see page 23)
Vv. wv Vv Position the drain hose correctly
Remove internal packing (see
p. 7)
Adjust the feet (see page 10)
Move the machine; it should
rest freely on its feet
v wwv v Remember to shake out large
items (e.g. sheets) when
loading
> Run the draining programme
(N), reduce the load and
continue
Wait 1 - 2 minutes after the
end of the programme before
opening the door (door pilot
light off)
> Drain the water by running the
draining programme (N)
If, after the above checks,
there is still a fault, call your
nearest Zanussi Service Force
Centre, whose address and
telephone number can be
found on the following pages.
Please make sure you give
the model and serial number
of the appliance. This infor-
mation can be found on the
rating plate (see picture), or
on the guarantee certificate.
Original spare parts can be
purchased from Zanussi
Service Force Centres.
In-guarantee customers
should ensure that the above
checks have been made as the
engineer will make a charge if
the fault is not a mechanical or
electrical breakdown.
Please note that proof of
purchase is required for any
in-guarantee service calls.