Table of Contents
Advertisement
OOR REVERSAL
The door of this washing
machine is designed for door
reversal.
To carry out this operation,
proceed as follows:
Bend
and
disengage
the
end of the closing catch from
the door (1), then rotate it
90° to remove
it from its
seating.
Using a screwdriver, rotate
the plastic cap (2) 90° and
remove it.
Fit the cap (2) in the hole
left free by the closing catch
and rotate it 90° so as to lock
it into position.
Fit the closing catch (1) and
rotate it 90° in the hole left
free by the cap, making sure
that the engaging
tooth
is
facing towards the right side.
Remove
the
door
by
unscrewing the two screws
fastening the bottom hinge
(3).
Unscrew
the two plastic
screws (4) and conceal the
holes
of the
previously
removed screws.
Remove the stop hook (5)
by pressing it from the upper
part outwards, thus releasing
it from the cabinet.
Take out stud (6) pulling it
outwards from the bottom.
Refit the stop hook (5) and
stud (6) on the opposite side.
Remove
the door closure
(7) bending the upper tongue.
Remove
the
stud
(8)
bending the upper tongue.
the
door
Reassemble
closure (7) and stud (8) by
reversing their position, then
press
thoroughly
until
hooking the tongue.
Fasten
the
door
on
the
opposite side using the hinge
(3)
and
the
previously
removed screws.
Check the door is aligned
with
the cabinet;
to make
this
operation
easy,
it is
advisable
to
unloose
the
screw (9) by two turns, then
tighten the screw again.
Fit
into
the
seating
provided
on
the
door
the
flexible
end
of
the
door
closing catch (1).
25
Advertisement
Table of Contents
